Dump list does not appear on the tablet.

Issue

The dump list on Smart Construction Fleet is not displayed on the tablet.

 Cause

The main cause is that the basic information of Smart Construction Fleet and tablet are not match.

How to deal

1) Check the settings on the tablet device following below.

• Start Smart Construction Pilot on the tablet and select "Payload Meter."
• Select "Settings" from the menu, press the excavation icon, and enter the password: 31415 (if the app version is older, enter ll?2017).
• It is able to open the Machine Settings after inputting the password so enter the necessary information for the "Model", "Type", and "Serial Number" in the "Basic Info".

*Caution

If payload calibration has been completed, please proceed without entering the base machine information.

For using dump list, it must be done that the jobsite is created, and the dump and construction equipment are linked there on Smart Construction Fleet or Smart Construction Fleet Lite.

2) How to input manually if there is no selection of "Model" and "Type" in 1) procedure.

• Tap the box to switch to the manual input screen, then enter the model and type.

*Caution

The "Model", "Type", and "Serial Number" registered for the payload construction equipment on the Smart Construction Fleet side and the "Model", "Type", and "Serial Number" registered on the machine setting screen on the tablet side must all match in order for the linkage to work. If even a single character is wrong, the machine will not be linked. so please make sure to enter the correct information.